Avermedia ESS1304 NET Bedienungsanleitung PDF herunterladen (Seite 52)

8.1.1.4 Alarm/Sensor Setup

(1)

(2)

(3)

(1) Sensor Setup

- Sensor Status

Customize the initial state of the attached sensor for every camera. Refer to the table

below to customize the sensor state.

Not installed: Indicates that there is no sensor connected

Normal open: Indicates that the initial state of the sensor is normal open. Video

recording initiate when there is a changes in the sensor state

Normal close: Indicates that the initial state of the sensor is normal close. Video

recording initiate when there is a changes in the sensor state

- Sensor Record Time

Set the amount of time (in second) to record after the sensor has been triggered

- Alarm Out Time

Set the amount of time (in second) to continue sending the alarm once activated

- DVR Video Loss Alarm

Enable/disable the alarm when channel video is lost. Select the channel for video

alarm loss.

(2) Mail Alarm Setup

Enable/disable alarm sending mail when alarm has triggered at the selected condition.

- HD Fail Alarm: Issue an alarm when hard disk of DVR system is failed.

- Motion Alarm: Issue an alarm when the selected channel has been detected the

1 2 ... 47 48 49 50 51 52 53 54 55 56 57 ... 72 73

Keine Kommentare

Avermedia ESS1304 NET Bedienungsanleitung Seite 52